Let’s take a look at some methods we will simply manipulate layers with After Results keyboard shortcuts.
Invert order of layers
Generally while you create or paste layers, they don’t at all times go within the order you had hoped. If we now have a couple of layers and need to invert the order in order that the underside layer goes on prime, the highest layer goes on the underside, and many others. — there’s a fast means to do that. First, choose the layers you need to invert and choose “Minimize.” That is Command + X on the Mac, Management + X on the PC. Then, paste the layers again, which is Command + V on the Mac, Management + V on the PC. Now the layer order has been flipped.
Transfer layers up/down
To maneuver layers up above different layers, spotlight a layer and choose Command + Alt + Down Arrow, which is Management + Alt + Down Arrow on a PC. The identical command with the up arrows strikes a layer up. I additionally use Command + ] or Command + [ to do the same thing on a Mac.
Command + Shift + [ or Control + Shift + [ moves your selected layer to the bottom of the composition. The same command with the ] bracket strikes a layer to the highest of the composition.
Trim layers
Alt + [ or Option + [ sets your layer in point by trimming to this point in time. Alt + ] or Choice + ] units your layer finish level by trimming to this time limit.
Sequence layers
If you wish to sequence layers in order that layer 2 is available in a sure variety of frames after layer 1, and layer 3 is available in after layer 2, there’s additionally a straightforward means to do this. Together with your layers beginning on the similar time, choose them. Transfer the time indicator to the length you need the sequence to be. Then, trim all of them all the way down to this length utilizing Alt + ] or Choice + ].
Then, right-click on one of many highlighted layers and choose Keyframe Assistant, then Sequence Layers. Simply hit OK to house your layer beginning factors the quantity of frames you chose earlier. Or, to have some overlap, choose the Overlap checkbox and enter the variety of frames for overlap.
Then, change the endpoint of your layers to your required length.
Transfer layers in time
To maneuver the start line of a layer, simply press [. This does not trim, but rather shifts the entire layer to start at this point. To shift the end point of a layer, press ].
Cut up
Lastly, to separate a layer into two components, transfer your time indicator to the specified time and choose Command + Shift + D or Management + Shift + D to separate the layer at that time.
