You’re keen on photographing on the seashore or desert. However how do you retain sand and crud out of your tripod? Listed below are a number of options!
Prolong the underside section first
At all times lengthen the underside section first. You may have to jam your tripod six inches or extra into the watery sand on the coast or some sand dunes within the desert. Nonetheless, on this manner, you possibly can scale back the sand going into the locks.
Wipe and rinse your tripod
I’m admittedly responsible of not doing this sufficient within the desert, though I do that constantly on the seashore. Nonetheless, wiping your tripod with a moist fabric after utilizing it does wonders for preserving the crud out of your locks and the inside of your tripod legs.
If you happen to don’t have a moist fabric or towel out there, attempt to see in the event you can rinse them off elsewhere or, on the very least, use one thing dry to wipe it off.
Examine the underside of your tripod
Many tripods include rubber toes. If these are free or fall off, this may expose an open screwhole on the underside of your legs. Sadly, this can be a surefire strategy to fill the within of your tripod legs stuffed with crud. You don’t need that, do you? No, in fact not! Seal these up by getting new rubber toes or putting a screw in there to forestall this.
Lube your tripod
Regardless of our greatest efforts, generally a tripod will get grit or sand or dust inside it. The legs may not slide easily out or in. You may hear some crunching once you slide the legs or in the event you use the locks. Chances are you’ll have to take it aside, clear it and lube it with marine grease. Put it again collectively, and it’s nearly as good as new!
Good high quality tripod corporations usually have particular instructions for the way to do that on their web site or proprietor’s guide. As with every gear, a little bit of care and upkeep is an exquisite factor.
